User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
102 PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
Description of Buttons and Functions
The following section describes the buttons and functions of the OpenNet LAN
Screen. Subsequent sections will discuss each function in detail.
Button Function
Master Designates the system as the Device Master, which controls the user defined
parameters on systems throughout the OpenNet LAN (page 103).
Diagnostics Displays the OpenNet Diagnostics screen (page 116).
System Displays the OpenNet System Configuration screen (page 104).
Assign TX Displays the Assign Transceiver screen. (page 135)
Program AT Displays the Ambulatory Transceiver (AT), programming screen.
(page 123). See the Programming Transceivers (page 122) section for
details.
Program IT Displays the Instrument Transceiver (IT), programming screen. (page 129).
See Programming Transceivers (page 122) for details.
Print DM Prints the Device Master report, which displays the global, as well as indi-
vidual, parameters for each Access Point.
LAN Displays the OpenNet LAN Configuration screen, which is allows you to set
the OP Band, Ext Sync, and update Access Points (page 104).
• This button is only available on the Device Master system.
Access Point Displays the Access Point Settings screen, which allows you to configure the
Access Point settings (page 106).
• This button is only available on the Device Master system.
RF Module Displays the RF Module screen, which allows you to configure the RF Mod-
ule settings (page 111).
• This button is only available on the Device Master system.