User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B 111
All information contained herein is subject to the rights and restrictions on the title page.
Configuring RF Modules
You can view the current RF Module configurations for each Access Point on the net-
work with the RF Module Settings screen.
To view RF Module settings:
1. Access the OpenNet LAN screen (page 101).
2. Click the RF Module button to open the RF Module Settings screen (fig. 66),
or you can click the Mod Config button on the Access Point Configuration
screen (see “Configuring Access Point Parameters” on page 108).
Fig. 66. RF Module Settings
3. Click the Status button to open the RF Module Status screen (see fig. 67 on
page 112), which allows you to view the current status of each RF Module in
the blackboard.
4. Click the Remove button to remove a selected RF Module from the RF Mod-
ule Settings screen and the OpenNet LAN.
• A warning popup will display requesting you to click either Yes, which will
remove the selected RF Module, or No, which will close the popup and leave
the RF Module unchanged.
5. Click the Exit button to close the RF Module Settings screen and return to the
OpenNet LAN screen.