User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
110 PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
Configuring Access Point Parameters - Part 2
The second page of the Access Point Configuration screen allows you to configure
additional Access Point parameters.
1. Click the Next button on the Access Point Configuration screen (see “Access
Point Configuration Screen” on page 108) to open the Access Point Configu-
ration Page 2 screen (page 110).
Fig. 65. Access Point Configuration Screen - Part 2
2. Select the desired Access Point number by clicking the up and down arrows,
which will cycle through the available Access Points and update the fields
with settings for each selected Access Point.
3. Click the Default Gateway button to open a keypad that allows you to set a
valid gateway address for the selected Access Point. This button is for admin-
istrative purposes only. Do not attempt to set the Default Gateway.
4. Click the Subnet Mask button to open a keypad with which you can enter the
OpenNet LAN subnet mask for the system. This button is for administrative
purposes only. Do not attempt to set the Subnet Mask.
5. Click the Multicast TTL button to open a keypad that allows you to set a
valid Mulitcast Time to Live (TTL) for the selected Access Point. Valid
values are between 1 and 255. Set the Multicast TTL to 1 unless instructed to
do otherwise. This button is for administrative purposes only. Do not attempt
to set the Multicast TTL.
6. Click the Prev button to return to the Access Point Configuration screen
(page 108).
7. Click the Exit button to close the Access Point Configuration screen and
return to the Access Point Settings screen.