User manual

APPENDIX 1: S-REGISTER TABLE
1 - front panel lock
bit 6,5 00 - AT%G0 auto FB/FF disable
*01 - AT%G1 auto FB/FF enable
10 - AT%G2 Auto FF off but FB on
11 - reserved
bit 7 0 - AT%U0 autobauding off
*1 - AT%U1 autobauding on
S30 13 -dBm Leased Line Tx Level (0..-31 dBm)
S31 00000000 binary Bit Mapped Options
bit 0 - leased to dial
0 - manual*
1- auto
bit 1 - dial to leased
0 - manual*
1- auto
bit 2 - V.32 auto FFFB by Retrain
bit 3 - reserved
bit 7,6,5,4 - backup tel. (#0~9)/no dial backup
S32 0 - reserved
S33 Test time(minute)
S34 Test time(second)
S35 30 second OH by DTR timer (default 30 seconds)
S36 D to L timer (default 60 mins)
S37 2 second Redial delay, Immediately 1….255 Second
S38 00000000 binary V34 Baud Rate Selection
bit 0 - enable 2400 /disable 2400
bit 1 - reserved (this bit always must be
set)
bit 2 - enable 2800 /disable 2800
bit 3 - enable 3000 /disable 3000
bit 4 - enable 3200 /disable 3200
bit 5 - enable 3429 /disable 3429
bit 7,6
Break type during Normal, V.42 or
MNP operation
00 AT\K0 break -0 (destructive)
01 AT\K1 break -1(nondestructive)
*10 AT\K2 break -2 (queue)
11 - reserved
S39 reserved
S40 Call back time(unit : second)
0 - Disable acll back
1..255 - Second
S41 00000001 binary Bit Mapped Options
bit 1,0 - connect message display
00 - ATW0 CONNECT with DTE
speed
*01 - ATW1 CONNECT with CARRIER,
PROTOCOL and COMPRESSION
10 - ATW2 CONNECT with DCE speed
11 - reserved
bit 2,3,4,5 - reserved
bit 7,6 - DTMF level selection (Low Band /
High Band)
00 -8 / -6 dBm
01 -10 / -8 dBm
10 -12 / -11 dBm
11 -11 / -9 dBm
No Default Unit Function Description
63