User manual

CHAPTER 3 : FRONT PANEL AND MENU TREE
3.5.6 CONFIG DTE MENU
Item Name Command Description
DTE Speed
300 bps
600 bps
1200 bps
1800 bps
2400 bps
3600 bps
4800 bps
7200 bps
9600 bps
12000 bps
14400 bps
16800 bps
19200 bps
21600 bps
24000 bps
26400 bps
28800 bps
31200 bps
33600 bps
38400 bps
57600 bps
76800 bps
115200 bps
AT
This setting is used to determine DTE speed when auto
speed conversion is ON in V.42 / MNP / normal mode.
*When using direct mode and all the synchronous
modes, this setting will not available and DTE speed
will be determined by modem speed, DTE speed =
modem speed.
*The throughput is improved by using data
compression, enhance this set higher than the modem
speed is suggested to enable more effective operation.
*When use "AT" command and auto baud rate detect
function "ON", this setting will be replaced by
identified speed.
*The Auto baud rate function can detect all the listed
DTE speed.
/Default = 57600 bps.
Flow Control
AT\Qn Used to set flow control between terminal and modem
when using V.42/MNP and normal mode (asynchronous
mode only).
Off AT\Q0 /No flow control
X-ON/X-OFF AT\Q1 /Software control, used in text data.
CTS Only AT\Q2 /Hardware control identical to RTS/CTS control, but
modem send the data in spite of RTS from DTE,
unilateral control.
RTS/CTS AT\Q3 /Hardware control, bilateral, accept any type of data
(default).
DTR CTL
AT%Dn Modem action select for DTR from OFF to ON.
108-2 AT%D0 /Same as V.25 108.2 DTR operation (default).
108-1 AT%D1 /Same as V.25/V.25bis 108.1 DTR operation. When
DTR is from OFF to ON,the modems will dial the
designed preset telephone number or answer according
to the current ring count.
DTR Off Action
AT&Dn On originate and answer site respectively modem action
select for DTR from ON to OFF.
Forced On AT&D0 /Force DTR in ON position
A power-on auto dial operation can be achieved when
operating with DTR ON auto dial (default).
Command mode AT&D1 /Return to the command mode.
30