User manual

CHAPTER 3 : FRONT PANEL AND MENU TREE
3.5.2 DIAL MENU
Item Name Command Description
Dial a Number
\#0...#9
ATDSn Dial out a preset telephone number #n(n=0..9). This function
can interact with the auto redial function or dial line auto
establishment function.
Edit a Number
\#0...#9
AT&Zn = xx Edit telephone number #n (n=0..9) for up to 20 digits each
group.If the "@" is included inside the number and auto-redial
is ON, then it will redial next number after no answer until the
number without "@". If it is still unsuccessful then retirn to the
first number. Up to 10 intelligent redial group is allowed. #1
xxx@
→#2 xxx@ ... →#n xxx →#1 xxx@ →...
Ring Times
ATS0=n Auto answer activates when detected ring count = n
(default=1).
**If 108.1 (DTR ON Auto Dial/Ans) is used for auto answer,
it must be set to OFF and the answer shall be activated by
DTR provided by DTE (default value=1 times).
Auto Ans Off ATS0=0 /Turn off the auto answer function.
1..255 Times /An auto answer will be given when bell rings 1..255 times.
Progress Tone
ATXn Enable detecting of busy tone or dial tone to proceed dialing
and showing the connection
Basic ATX0 /Don't care any tone and do not show line connection speed.
Don't Care ATX1 /Don't care any tone and show the line connection speed.
Dial Tone ATX2 /Don't detect busy tone but show the line connection speed.
Busy Tone ATX3 /Don't care dial tone but show the line connection speed.
Dial+Busy Tone ATX4 /Do care dial tone, busy tone and show the extended result
code (default).
Redial Delay
ATS37=n Pause time between auto redial
Immediately ATS37=0 /Redial Immediately
1..255 seconds ATS37=n /Set up redial time ( /Default=2 second)
Dial Type
Select dial type
Tone ATT /Tone (DTMF) dialing mode
Pulse ATP /Pulse dialing mode
SPK.Control
ATMn Monitoring speaker switch control.
Off ATM0 /Keep speaker always off
Until DCD On ATM1
/Speaker turn on until DCD ON,then turn off (default).
Always On ATM2 /Keep speaker always on.
Off When Dial ATM3 /Turn on speaker after dialing is completed, and then detect
until to find out carrier and then turn off speaker.
SPK. Volume
ATLn
Speaker volume control.
Low ATL0 /Set speaker volume to low.
Medium ATL1
/Set to medium (default).
High ATL2
/Set to high..
25