User manual

CHAPTER 2: INSTALLATION
2.6 Connecting With Dial Line
To connect your modem to a permissive RJ11 voice jack and dial line, follow
this procedure: On the rear panel of MODEM, there is an 8 pins RJ-45 jack used for
Leased Line, beside this, there are two RJ-11 6 pins jack, one is “DIAL LINE“ and the
other is "PHONE". Connect the “PHONE” jack to telephone set and then connect the
telephone line to "DIAL LINE" jack.
The pin layout of the “PHONE” connector for RJ11 operation is as follows:
Pin. Color “PHONE”pin defined
1 No Connect No Connect
2 Black Not used
3 Red Tip
4 Green Ring
5 Yellow Not used
6 No Connect No Connect
The pin layout of the DIAL connector for RJ11 operation is as follows:
Pin. Color “Dial Line”pin defined
1 No Connect No Connect
2 Black Not used
3 Red Tip
4 Green Ring
5 Yellow Not used
6 No Connect No Connect
ON
OFF
DTE
PHONE LEASED DIAL
DIAL
LINE
RED
GRN
TELEPHONE
BOX
RJ11 RJ11
RJ11 modular telephone cable
RJ11 modular telephone cable
Figure 2-1 Dial Line connecting diagram
12