Specifications

Component View
Figure 2-2 shows the component view of the modem. This view shows:
 Three configuration switch blocks, designated SW1, SW2, and SW3. See page 9.
 Jumpers located in various positions on the modem. Do not change or remove the straps from these jumpers.
 Edge connectors at the back of the modem, which plug into the backplane of a BLACK BOX® Modem Rack II
(or equivalent rack from Telenetics Corporation or Motorola/UDS).
Switch Block SW3
Switch Block SW1 Switch Block SW2
Configuration
Switch Blocks
Edge Connectors
Figure 2-2. Component View of Modem
Installation Summary
The modem installation involves the following steps:
1. Configuring the modem. See page 9..
2. Connecting to a transmission line. See page 18.
3. Connecting an RS-232 device. See page 18.
Page 8