User`s guide

Gyro Control Unit (GCU)
User’s Guide
36
MaxMetrix, Scottsdale, AZ
PN: GCU-2K1-UG:RevI.2 NGC
4.2 PARAMETER BUTTONS AND STORAGE
Table 2 Parameter Button Usage
Button Description
Read Calibration Reads the calibration file named with the filename associated with the serial
number (i.e., G-0000-0000-0000.dat) from of the associated GCU. Note: the zeros
in the example will actually be the unique serial number reported back from the
specific GCU module.
Set Defaults Reads the default values file named “defaults.dat”
Read Gyro Contents Reads the values from the GCU module FLASH memory.
Save Calibration Saves the current values in the CAL/STATUS and FILTERS TAB and stores them
in the FLASH memory on the GCU and writes them to the file on the test computer
with the filename of the associated serial number from of CGU.
Write to DSP Writes the current values from the GUI to the DSP RAM. Note: they are only in
RAM, they will not remain after power is turned off. To make them permanent the
user must select the Save Calibration Button.
Read From DSP Read the current values from the DSP RAM and updates the text boxes in the filter
TAB.
Table 3 Parameter Button Usage