Specifications

1.0 INSTALLATION

There is no intent on the part of Data Aire, Inc. to deﬁ ne local codes or statutes which may

supersede common trade practices. The manufacturer assumes no responsibility for their

interpretation. Consult local building codes and the National Electrical Code for special

installation requirements.

1.1 Room Considerations

Precision air conditioning equipment is designed to control spaces within close tolerances of

temperature and humidity. However, the room must be built with a proper vapor barrier. A ﬁ lm of

polyethylene is often used on walls and ceilings. Walls and ﬂ oors must also be painted with a vapor-

seal paint. Failure to provide a vapor barrier can compromise space conditions.

Introduction of outside air into the space should be minimized. Outside air in excess of 5% of the

total circulated air volume can have a signiﬁ cant effect on the overall space conditions and result in

poor space control.

1.2 Inspection

This Data Aire unit has been factory run-tested and has gone through a comprehensive inspection

prior to its packaging and shipment to ensure that it arrives in excellent condition. However, shipping

damage can occur and a visual inspection of the outer crating immediately upon delivery should be

performed.

Note any external damage or other transportation damage on the freight carrier’s forms. Inspect

the unit itself for internal damage. A claim should be ﬁ led with the shipping company if the equipment

is damaged or incomplete.

Loose items such as remote control panels, disconnect switch handles, spare belts and spare ﬁ lters

are packed inside the unit. Refer to the yellow shipping tag located on the unit door for details.

Freight damage claims are the responsibility of the purchaser. Action to recover losses

should be ﬁ led immediately. Please notify factory personnel of any claims.

1.3 Rigging

Move the unit in its upright position to the installation site. It is recommended that the unit be

protected from damage to the decorative doors during any storage or moving. Removal of the

decorative doors is easily accomplished and may be done when moving equipment.

The shipping skid should be left in place if the unit is being moved with a forklift. If the unit is

being lifted, use spreader bars to prevent damage to the doors and panels.

The unit has 3/4” holes in the shipping skid to which casters with 3/4” stems can be attached. This

allows easy movement down halls, into elevators and through doorways. If clearance is a problem