User manual

User Manual of Network Speed Dome

Figure 6-7 TCP/IP Settings

2. Configure the NIC settings, including the IPv4 Address, IPv4 Subnet Mask and

IPv4 Default Gateway.

3. Click to save the above settings.

Notes:

 If the DHCP server is available, you can check to automatically obtain

an IP address and other network settings from that server.

 The valid value range of Maximum Transmission Unit(MTU) is 500 ~ 9676. The

default value is 1500.

 The Multicast sends a stream to the multicast group address and allows multiple

clients to acquire the stream at the same time by requesting a copy from the

multicast group address.

Before utilizing this function, you have to enable the Multicast function of your

router and configure the gateway of the network speed dome.

 If the DNS server settings are required for some applications (e.g., sending

email), you should properly configure the Preferred DNS Server.

Figure 6-8 DNS Server Settings

6.3.2 Configuring Port Settings

Purpose:

If there is a router and you want to access the speed dome through Wide Area

Network (WAN), you need to set the 3 ports for the speed dome.

Steps:

1. Enter the Port Settings interface:

Configuration > Basic Configuration > Network > Port

Or Configuration > Advanced Configuration > Network > Port

Figure 6-9 Port Settings