User manual

- 20 -
● Device Control
It is used to control PTZ and lens, ex. PTZ direction, focus, zoom and contact closure
such as light, power and rain brush output as figure5.9
Fig.5.9
Choose different protocol type and set device address to control different devices.
Protocol（Fig 5.10）:
[Protocol]: Contains the following Protocols: PTZ_PELCO_D, PTZ_PELCO_P,
PTZ_TC615_P, DOME_PELCO_D DOME_PELCO_P.
[Protocol state]: Automatic identification.
[Address]: You can manually enter the address of the front-end fixed point device, the
effective address range: 1 to 255.
[Baud rate]: requires the user to enter the “configuration parameters "----" PTZ Settings”
interface to set up.
[Set]: Set the preset position; Enter the preset number in the blank column, click "Set"
button, the camera’s current state of a preset called preset “1”; accordingly you can add
multiple preset positions.
[Call]: call the preset position; Enter the preset number in the blank column, click "Call" to
call the preset position, the camera will automatically rotate to the preset position.