Owner`s manual

IMPORTANT: THE HORIZONTAL
HEAT SHIELD INCLUDED WITH THIS
FIREPLACE MUST BE INSTALLED
WHEN USING A 90-DEGREE ELBOW
DIRECTLY OFF THE TOP OF UNIT TO
HORIZONTALLY POSITION THE
VENT SYSTEM. THIS INCLUDES ANY
CORNER INSTALLATION.
HORIZONTAL VENT HEAT SHIELD
VENTING
1. Loosen, but do not remove center
three screws on top of fireplace.
2. Bend horizontal heat shield at perforation to a 90° angle. Slide the
(3) slots on horizontal vent heat shield under loosened screws.
3. Re-tighten screws.
90° ANGLE BEND
PAGE 25
ATTACHMENT SCREWS
NOTE:
STAND-OFF HEAT SHIELD
NOT SHOWN FOR CLARITY
PURPOSES ONLY.