Owner`s manual

CAUTION: DO NOT
CONNECT HIGH VOLTAGE
(115V) WIRE TO THE GAS
VALVE!
If desired, a thermostat (wireless style also available), wall
switch, or remote control assembly may be used to turn the
fireplace „OFF‟ and „ON‟. Only ONE of these may be installed.
Follow instructions included with each assembly.
WALL SWITCH / THERMOSTAT:
Run low-voltage (thermostat) wires from terminals on the gas
valve to the desired location of wall switch or thermostat.
Attach the appropriate connectors to wall switch / thermostat
wires and connect to the top and bottom terminals marked
TH / TPTH on the gas valve.
REMOTE CONTROL:
Follow instructions included with the remote control.
IMPORTANT: The insulated cover included
with the remote control must be placed over the
remote receiver to prevent overheating.
IMPORTANT: If ON/OFF rocker switch
wires are not disconnected, the ON/OFF
rocker switch on the millivolt board must
be in the „OFF‟ position for proper
operation of any of these components.
If rocker switch is „ON‟, the fireplace burner will
operate until it is turned „OFF‟ by the rocker switch.
A wall switch, thermostat, or remote control will not
turn the fireplace „OFF‟ when it has been turned
„ON‟ by the rocker switch.
NOTE: The fireplace must be turned
„ON‟ and „OFF‟ by the same method. For
example: If fireplace is turned „ON‟ by
the remote control, it must be turned
„OFF‟ by the remote control.
Remote Control Wiring Diagram
Thermostat Wiring Diagram
THERMOSTAT / WALL SWITCH / REMOTE
NOTE: INSTALLATION OF THERMOSTAT
OR WALL SWITCH SHOULD ONLY BE
DONE BY A QUALIFIED INSTALLER.
PAGE 20
OPTIONAL:
Disconnect ON/OFF
rocker switch wires from
the back of gas valve.