Installation manual

6
CONTROL SYSTEM COMPONENTS
FAN CONTROL MODULE
Figure 6a
RECEIVER
Figure 6b
INITIALIZING THE SYSTEM FOR THE FIRST TIME
NOTE This procedure must be performed every time batteries are replaced in Receiver or Transmitter.
1. Move slider switch on receiver to OFF position.
2. Install 4 AA batteries (included in components packet) into receiver battery
bay.
3. Move slider switch to REMOTE position.
4. Using the end of a paper clip, or other similar object, press button through
hole marked PRG on receiver front cover. Receiver will ‘beep’ three (3)
times to indicate it is ready to synchronize with a transmitter.
5. Install 3 AAA batteries (included in components packet) into transmitter
battery bay (located on base of transmitter). Push the ON button. The
receiver will beep four (4) times to indicate the transmitter’s command is
accepted and set to the particular code of that transmitter.
6. Turn On fan control module, switching to ON ( | ) position.
7. The system is now initialized.
Figure 6c
SYSTEM OPERATION