Installation manual

CONTROL BOARD REMOVAL / INSTALLATION

1. Turn fireplace off.

2. Shut off gas supply at manual shut-off valve.

3. Disconnect gas line flex tube from manual shut-off valve.

4. Disconnect any wall switch, remote control or thermostat wires from top & bottom

terminals on gas valve or unplug all components from receptacle, disconnect all

wiring harnesses attached to gas valve.

5. Remove upper hood, upper louver, lower grill and glass frame assembly.

6. Remove logs, bottom refractory panels and refractory panel set.

7. Remove pilot shield.

8. Remove burner / burner heat shield assembly by lifting up off the orifice and out of

firebox.

9. Remove and save (8) screws securing control board, lift board out of firebox being

careful not to damage sealing gasket lying underneath.

BURNER HEAT SHIELD

BURNER

PILOT SHIELD

PILOT

ASSEMBLY

ORIFICE

CONTROL BOARD REMOVAL

CONTROL BOARD INSTALLATION

1. Install control board,, aligning holes in control board with holes in firebox bottom.

Secure to firebox bottom with (8) screws previously removed.

2. Install burner / burner heat shield assembly, making sure burner venturi is seated

over burner orifice and pilot assembly is above burner.

3. Reinstall refractory panels (if applicable), pilot shield, bottom refractory panels and

log set.

4. Reconnect gas line to manual shut-off valve.

5. Reconnect any wall switch, remote control or thermostat wires to top and bottom

terminals on gas valve or re-connect all wiring harnesses to gas valve. Plug all

components into electrical outlet.

6. Reinstall glass frame assembly, upper louver, upper hood and lower grill.

7. Turn gas on. Verify proper log placement, operation of fireplace, and any

electrical components.

Figure 27a

WARNING

DO NOT OPERATE THIS FIREPLACE WITHOUT SEALING GASKET

(LOCATED UNDER CONTROL BOARD) IN PLACE.

IF GASKETING IS DAMAGED, IT MUST BE REPLACED.

CAUTION

If burner and/or pilot have been burning, use appropriate protection to

avoid burns or personal property damage before removing any components.

CAUTION

CHECK ALL CONNECTIONS FOR LEAKS WITH SOAPY WATER, WHETHER

FIELD OR FACTORY MADE.

NOTE You components may look slightly different than ones shown.