Installation manual

26
#DSL-50A LOG SET INSTALLATION
#D7
#D12
#D10
#D11
#D8 #D9
Position #D7- #D9 logs, aligning holes in bottom of logs with corresponding mounting pins on burner.
Place #D10 - #D11 logs as shown below, aligning logs with corresponding grooves in base logs.
Align notch in bottom of #D12 log with burner grate, setting down into position.
Randomly place ‘Klinkers’ in this area. Do not place directly over burner ports.
Use a steel or stiff bristle brush to distribute Rock Wool Embers onto logs and burner.
Figure 26b
Figure 26a
NOTE
Logs are installed in numerical order. Log numbers are located on bottom of each log. Refer to following instructions and
illustrations for proper placement.
CAUTION
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
ATTENTION
If converting to LP (propane) gas or installing optional firebrick refractory, do so now before installing log set. Follow
instructions included with conversion kit and / or refractory kit.