Installation manual

12
GLASS FRAME ASSEMBLY
1. Place glass frame assembly onto fireplace front.
2. Pull top handles out and down to secure assembly top.
3. Pull bottom handles out and up to secure assembly bottom.
REMOVE GLASS FRAME ASSEMBLY
1. Locate spring-loaded handles securing glass frame assembly at top &
bottom of firebox.
2. Pull bottom handles out and down to release assembly bottom.
3. Pull top handles out and up to release assembly top.
4. Remove glass frame assembly from fireplace.
INSTALL GLASS FRAME ASSEMBLY
GRILL SET
1. Align hooks in upper louver to slots located in fireplace face. Set
down into position.
2. Insert upper hood flange into clips located at top of upper air passage,
keeping in mind this is a fairly tight fit.
3. Partially thread (2) screws (included in components packet) into nuts
at each end of lower grill. Secure to fireplace by threading screws into
corresponding holes in inside flange of lower grill opening. The lower
grill can now be opened and closed to access gas valve and controls.
1. Use both hands to pull hood out of upper air passage clips.
2. Lift upper louver up and out of slots.
3. Remove screws securing lower grill at each end to remove from
fireplace.
GRILL SET INSTALLATION
GRILL SET REMOVAL
Thread screws into nuts on each end
of grill and secure to lower grill opening.
3
Upper hood clips
2
Slide flange on upper hood into
clips at top of upper air passage.
1
WARNING
DO NOT OPERATE THIS FIREPLACE WITH THE GLASS FRONT REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
CAUTION
TO PREVENT GLASS FRAME ASSEMBLY FROM FALLING FROM FIREPLACE AND BECOMING DAMAGED, FOLLOW THESE
INSTRUCTIONS EXACTLY WHEN REMOVING AND INSTALLING GLASS FRAME ASSEMBLY.
Figure 12b
Figure 12a