Use and Care Manual

CLEANING YOUR PANCAKEBOT

Make sure you clean your PancakeBot after each use.

1. The Dispenser Bottle can be removed for cleaning. To disassemble your

Bottle, unscrew the Nozzle from the black ring that is located near the Nozzle.

Then unscrew the black ring from the Bottle. Be careful not to lose the

silicone seal that rests on the inside of the black ring or the silicone seal in the

Dispenser Bottle Fill cap. Use a gentle bottle brush or cloth and mild soap to

clean the interior of the Dispenser Bottle and all parts. Wash the Cap and Air

Hose with warm, soapy water. Dry thoroughly.

2. There is a tiny hole in the Dispenser Bottle Fill Cap that allows for extra

pressure to escape. Make sure that it is not blocked with batter or residue.

3. Make sure the Griddle has cooled down before removing to clean. Wipe

down with a sponge and warm, soapy water. Rinse carefully. Do not submerge

in water or allow the Probe or Probe Socket to get wet. More detailed cleaning

instructions are included with your Griddle.

4. Use a clean, damp cloth to wipe the PancakeBot Base.

5. Open the Filter Housing, remove the Filter, and rinse thoroughly. Let dry

completely before re-inserting it back into the Filter Housing.

MAINTENANCE