Use and Care Manual

14
HOW TO USE YOUR PANCAKEBOT
LOADING THE BATTER
For optimal performance, please follow the instructions on pg. 19 on making your
batter. To ensure that the batter is clump-free, strain the batter before loading into
the Dispenser Bottle. We recommend that you remove the Dispenser Bottle from
the PancakeBot before lling so that batter does not leak onto the Griddle.
Watch the “How To” video on www.pancakebot.com to learn step by step.
1. Unscrew the Dispenser Bottle Fill Cap and remove the Dispenser Bottle from
the Dispenser Holder. Attach the Drip Cap to the tip of the Dispenser Bottle
Nozzle.
2. Fill the Dispenser Bottle with batter. Do not ll past the MAX line.
WARNING: Do not overll the Dispenser Bottle or tilt the Dispenser Bottle
while it is connected to the Air Hose and the PancakeBot is turned on. If you
see pancake batter entering the Air Hose, disconnect the Hose from the
Gantry and shut the PancakeBot off immediately. Thoroughly clean and dry
the Air Hose before reconnecting.
3. Screw the Dispenser Bottle Fill Cap back onto the Dispenser Bottle and attach
the Air Hose.
4. Slide the Bottle into the Dispenser Holder, aligning the Dispenser Bottle Spine
with the shortest Height Adjustment Slot. The shortest slot is for standby and
holds the batter furthest from the Griddle whereas the longest slot will be
used for printing. If you are using a taller griddle, you can use the shortest
slot for printing. Do not remove the Drip Cap until you have turned on the
PancakeBot.
Long Slot
Short Slot