Use and Care Manual

11
3. Hold the Gantry upright and align the two
Main Leg Connectors with the two holes on the
PancakeBot Base Main Leg. Make sure that the
Support Leg lines up with the groove on the
opposite side of the Main Leg on the PancakeBot
Base.
4. Slide the Gantry all the way to the opposite side
of the Control Panel.
5. Place the Griddle on the PancakeBot Base. Make
sure to place the legs within the stoppers located
on the PancakeBot Base. The Probe Socket
should be facing the back of PancakeBot (away
from the Control Panel).
6. Slide the Dispenser Bottle with Fill Cap attached
into the Dispenser. Make sure to align the
Dispenser Bottle Spine with the appropriate
Height Adjustment Slot (the shortest slot is for
standby and the longest slot is for printing).
HOW TO USE YOUR PANCAKEBOT