User Guide User Manual

User guide The Menu
83
First printing position (FormAdj) Sets the first print position of a form in n/72 inch, separately adjust-
able for each paper path.
The settings made here reduce the height of the printable area.
Press FormAdj (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: 0/72" to 220/72"
Default Setting: 12/72"
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
An alternative notation for FormAdj is TOF (Top Of Form).
Printhead gap manually (Head) This parameter is ignored if the automatic gap adjustment (AGA) is
activated; see Automatic gap adjustment (AGA)
(page 103).
Adjusts the printhead gap manually; separately adjustable for each
paper path.
Press Head (2) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: 0 to 100
Default Setting: 18
Select the Head = 18 parameter for normal paper. Use a greater dis-
tance for thicker paper.
Recommended values for the print head gap:
If you change this value, this may affect the print quality.
If the printout shows signs of smudging, we recommend that
you increase the print head gap.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Forml FormAdj
Online
Setup
21
3
4
Back Next
FormAdj= 12/72 * "
Online
Setup
Set < > Exit
21
3
4
Head
Online
Setup
21
3
4
Back Next
Head= 18 *
Online
Setup
Set < > Exit
21
3
4
thin thick
18 26 34 42 50 58