User Guide User Manual

User guide The Menu
69
Further Settings (Special) This parameter subgroup only appears if the serial port is used and
the ENQ/STX, ETX/ACK or ACK/NAK protocol is activated.
Press Special (2) key.
Error handling (ErrMode) On replaces the incorrect character with ?, Off deletes the entire
block.
Press ErrMode (2) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: On/Off
Default Setting: Off
Confirm the setting by pressing the Set key (1).
Block end character (Blockend) End-of-block character definition; On: LF, FF, CR, VT, ETX, DEL;
Off: ETX, DEL.
Press Blockend (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: On/Off
Default Setting: Off
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Special Protocol
Online
Setup
21
3
4
Back Next
ErrMode Blockend
Online
Setup
21
3
4
Back Next
ErrMode=Off *
Online
Setup
Set < > Exit
21
3
4
ErrMode Blockend
Online
Setup
21
3
4
Back Next
Blockend=Off *
Online
Setup
Set < > Exit
21
3
4