User Guide User Manual

The Menu User guide
66
Selecting emulation
(Emulate)
Selects the emulation. When a printer understands the control set
written for another printer type, it is said to emulate the other printer.
MTPL is also active in IBM or Epson emulation mode.
Press Emulate (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: Epson LQ-2550, Epson LQ-2170,
IBM Propr. XL24, IBM ProXL24+AGM,
MTPL, Genicom ANSI
Default Setting: Epson LQ-2550
You are using a sophisticated product. However you may find
additional or different emulations in this section depending on
the loaded firmware.
If the printer is switched to online mode after changing the emula-
tion, it performs a reset.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Bidirectional printing
(Bidir)
Setting On: Printer prints in both directions (bidirectional).
Setting Off: Printer prints only in one direction (from left to right).
Press Bidir (2) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: On/Off
Default Setting: On
Confirm the setting by pressing the Set key (1).
The setting On will not be overwritten by ESC sequences.
ESCChar Emulate
Online
Setup
21
3
4
Back Next
Epson LQ-2550 *
Online
Setup
Set < > Exit
21
3
4
Bidir I/O
Online
Setup
21
3
4
Back Next
Bidir=On *
Online
Setup
Set < > Exit
21
3
4