User Guide User Manual

User guide 2T model
49
2T model
Introduction This section describes how to handle the rear tractor (paper feed
from the rear), which is only available and permanently installed in
the 2T printer model in addition to the primary tractor (paper feed
from the front).
The Paperway parameter group in the menu of the 2T model differs
from the one of the standard printer as follows:
The permanently installed rear tractor is identified as “Trac3”
in the menu. “Trac2“ in the menu refers to the optional tractor
which can be installed both on the standard printer and the 2T
model. The optional tractor 2 can be installed by the user.
Rear tractor paper path
For information on the printable length and width of the forms
and other specifications, refer to Paper specifications
, page 136.
The 2T model cannot accommodate an additional automatic
single sheet feeder, which is available for some printer models.
8
Standard printer 2T printer
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
Tractor3 (standard, rear)
Tractor 1
Tracto r 2
Tractor 3