User Guide User Manual

User guide Settings
47
Setting the first printing
line (TOF)
You can use the TOF function for setting the position of the first print-
ing line for each paper source and each menu individually.
Before using the TOF function, you should first set the tear
position; see Setting the tear position
(page 46).
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bot-
tom edge of the first printing line A is aligned
with the tear edge B of the printer. The factory
setting for the first printing position (TOF) is
12/ 72" (4,23 mm/1/6 inch). This is equivalent to
the second line from the top.
Press the < (2) or > (3) key to move the first printing line to the de-
sired position. You can set values from 0 to 220/72" for fanfold pa-
per.
Confirm the input by pressing the Set (1) key. Press the Setup key.
The printer returns to the initial status.
The selection made will be retained after switching off the
printer.
Adjust Paperway
Menu Char
Online
Setup
21
3
4
TOF
Head Tear
Online
Setup
21
3
4
Computerdrucker
B
A
FormAdj= 12/72"*
Set < > Exit
Online
Setup
21
3
4