User Guide User Manual

Emulations User guide
156


<ESC><EM>R Print page


<ESC>F Bold OFF


<ESC>g Set character pitch to 15 cpi


<ESC>G Set double stroke


<ESC>H Reset double stroke

<ESC>H Set horizontal tab at current printhead position


<ESC>I<n>
n = 0, 8: Draft; n = 4, 12, 20: Draft DLL/n = 0, 8: HS; n = 4, 12, 20: HS DLL


<ESC>j<n> Single line feed back n/180 inch


<ESC>j Set printer to Off Line


<ESC>J<n> Single line feed n/180 inch

<ESC>J<n> Single line feed n/216 inch


<ESC>k<n> Select font


<ESC>K<n1> <n2> Set graphics print to 60 dpi


<ESC>l<n> Set left margin


<ESC>l<n> Select print mode


<ESC>L<n1> <n2> Set graphics print to 120 dpi


<ESC>M Set character pitch to 12 cpi (Elite)


<ESC>n Character generator LS2


<ESC>N<n> Set perforation skip


<ESC>o Character generator LS3


<ESC>O Reset perforation skip


<ESC>p<n> Proportional font ON/OFF


<ESC>P Set character pitch to 10 cpi (Pica)


<ESC>P<n> Proportional font ON/OFF


<ESC>Q<35> Deselect printer


<ESC>Q<n> Set right margin


<ESC>r<n> Select colour (reserved)


<ESC>R Reset all tabs


<ESC>R<n> Select national character set


<ESC>S<n> Superscript or subscript ON


<ESC><SI> Condensed printing 17.1 cpi ON


<ESC><SO> Double-wide printing ON


<ESC><SP><n> Set character spacing


<ESC>t<n> Select character set


<ESC>T Superscript or subscript OFF


<ESC>U<n> Unidirectional print ON/OFF


<ESC>Un Unidirectional print ON/OFF
MTPL
IBM
XL24
IBM
AGM
Epson
LQ-2550
Epson
LQ-2170
Code Function