User Guide User Manual
Emulations User guide
154
<ESC>[j Position paper back 1/180"
<ESC>[<n1> <n2>f Set absolute horizontal and vertical position
<ESC>[<n>+w Interface holding time n = 1 - 30 s
<ESC>[<n>+x Head position horizontal in n/720", also paper load pos.
<ESC>[<n>+y Printhead gap n = (0 - 100)
<ESC>[<n>+z Auto. or man. printhead gap adjustment
<ESC>[<n>SP q Load menu
<ESC>[<n1>...<n5>+v Paper handling options
<ESC>[<n1>...<n16>SP r Print transparent characters
<ESC>[<n1> <n2>f Set absolute horizontal and vertical position
<ESC>[<n1> <n2>SP 0 Change character size
<ESC>[<n1> <n2>SP D Select font
<ESC>[<n1> <n2>SP G Set character/line spacing
<ESC>[<n1> <n2>r Set top and bottom margin
<ESC>[<n1> <n2>s Set left and right margin
<ESC>[<n> a Set relative horizontal position
<ESC>[<n> d Set absolute vertical position
<ESC>[<n> e Set relative vertical position
<ESC>[<n> j Relative horizontal position back (to the left)
<ESC>[<n> k Relative vertical position back (to the top)
<ESC>[<n> p Set HMI
<ESC>[<n> q Set horizontal step
<ESC>[<n> SP \ Set additional spaces
<ESC>[<n> SP C Select character size
<ESC>[<n> SP f Set reduced spacing
<ESC>[<n> SP g Set character spacing
<ESC>[<n> SP h Line spacing
<ESC>[<n> SP s
Transmits the “n” character as an ASCII character (n= 0–255)
<ESC>[<n> SP U Beginning of line (default value)
<ESC>[<n> SP V End of line (default value)
<ESC>[<n> t Set form length in lines
<ESC>[<n> u Set horizontal tab
<ESC>[<n> v Set vertical tab
<ESC>[\<n1><n2> Perform relative horizontal step
<ESC>\<n1>;<n2> Transparent mode for the characters following
<ESC>^ Transparent mode for the character following
<ESC>_<n> Overline ON/OFF
MTPL
IBM
XL24
IBM
AGM
Epson
LQ-2550
Epson
LQ-2170
Code Function