User Guide User Manual

User guide Advanced menu

111

When you submit a print job which exceeds the paper width, the fol-

lowing message appears in the display:

The print job is stopped at the measured paper-end position after

printing the first line.

You can now either cancel the print job or load suitable paper. In the

latter case, the printer will resume the print job upon pressing the

Online key.

If you press the Online key without having changed the paper,

another line is printed until reaching the measured paper-end

position.

The sensor interprets dark areas with a width of 13 mm or

more as the right-hand paper edge.

If the sensor does not detect any black area, the maximum

possible printing width is used as the printable area.

If there is a sensor malfunction (e.g. because of dirt, a defect

or misinterpretation of the paper width) it is necessary to

deactivate the APW function (APW=Off), since otherwise the

printout will be too narrow or there will be no printout at all. In

this case contact your service technician.

Confirm the setting by pressing the Set (1) key.

Automatic detection of the