User Guide User Manual

Advanced menu User guide
106
Right-hand area (Rightzo) If the parameter is On, the print head travels from the right-hand per-
foration area towards the centre of the paper while the paper is mo-
ving. The Pagewid option must be correctly set in this case, see
Paper width (Pagewid)
(page 105).
Select the Rightzo menu (3).
Setting options: On/Off
Default setting: Off
If this parameter is On, the print head carriage travels to
the centre of the form while the paper is loaded.
Confirm your setting with the Set key (1) and press the Next key (4)
to access the next group of parameters.
Physical left margin (Physlm)
Select the Physlm menu (2).
Setting options: 0 to 30 in 1/10 inch steps
Default setting: 0/10 Inch
Permanent (physical) setting of the left margin. This parameter can-
not be changed by emulation-dependent margin settings. Margin
setting values entered by ESC sequences are added to the Physlm.
Note that this value is subtracted from the maximum printing
width of 13.6 inches.
Confirm the setting by pressing the Set (1) key.
All parameters described in the Paphand group may also be
defined via an ESC sequence (see Emulations
(page 145) or
Programmer’s Application Manual
).
Press the Next key (4) to access the next group of parameters.
Leftzon Rightzo
Online
Setup
Back Next
21
3
4
Rightzo=Off *
Online
Setup
Set < > Exit
21
3
4
Physlm
Online
Setup
Back Next
21
3
4
Physlm= 0/10" *
Online
Setup
Set < > Exit
21
3
4