User Guide User Manual

User guide Advanced menu
103
Form length (Forml) The Formlen function allows you to set the basic form length to
meet your requirements. 11 inches are usual in the USA, as op-
posed to 12 inches in Europe.
Select the Forml menu (2).
Setting options: 12 oder 11 Inch
Default setting: 12 inches for 220–240 V printers
11 inches for 120 V printers
The value defined here is set in all five menus and for all paper
paths. The setting made here is not changed by loading the default
(factory) settings by pressing all four function keys; see section Key
functions when turning on the printer (page 37).
Confirm the setting by pressing the Set (1) key.
Automatic gap adjustment
(AGA)
This function allows you to switch the Automatic Gap Adjustment
(AGA) off or on.
Select the AGA menu (3).
Setting options: Off/On
Default setting: On
AGA=On: printer checks paper thickness and changes gap adjust-
ment if necessary (default). Measurements take place
– after power-on
– whenever changing the paper path, when loading paper
AGA = Off: selects manual gap adjustment; the value can be set for
each paper source and each of the five menus available.
Confirm the setting by pressing the Set (1) key. The printer automat-
ically leaves test mode and assumes online mode.
Formlen AGA
Online
Setup
Back Next
21
3
4
Formlen=12" *
Online
Setup
Set < > Exit
21
3
4
Formlen AGA
Online
Setup
Back Next
21
3
4
AGA=On *
Online
Setup
Set < > Exit
21
3
4