User Guide User Manual

Advanced menu User guide
100
Advanced settings In the advanced menu, there are other settings available besides the
test functions.
` With the function PMS you have the possibility of activating the au-
tomatic paper motion sensor (PMS) in case of a paper jam.
` With the functon Forml you can adjust the form length.
` The function AGA switches the automatic printhead gap function on
or off.
` You can also select adjustments which facilitate handling paper
which may cause problems in printing due to its structure (Pa-
phand).
` The CX-bid menu option controls the bidirectionality of the parallel
interface.
` With the function Wrap, you can set line wrap and with the function
Sound beep at paper end.
` The Single menu option does not apply to this printer.
` The function Pap.back allows printing on paper with a dark back.
` You can use the HvyForm function to set the print head to print the
same line twice at double strike force in order to ensure that copy
paper produces optimum results even if it has a faint copying effect.
` If the parameter Sleepmod is activated, the printer switches to en-
ergy-saving mode after 30 seconds of inactivity.
` The APW function can be used to activate the automatic paper width
detection feature to prevent the printer from printing beyond the pa-
per edge.
` The AED menu option only appears, if a cut device is installed. It
corrects possible inaccuracies of the paper positioning at the tear
edge if the paper path is changed after a cutting action.
` With the SerialN function you have the possibility to change the se-
rial number of the printer.
` With the AssetN function you have the possibility to change the as-
set number of the printer.
` The GrSpeed function allows improved graphic speed.
` The function GrFreq has an effect on graphic and barcode print. A
lower print speed may affect the printout quality positive.
` The Ignore/Ignorchr function allows to ignore the printing of any
character
` With Jobcntl you can activate the PJL language. This language can
be used together with the internal Ethernet interface or a TallyCom
III Ethernet int
erface (or compatible).