Quick Start Guide Manual

Settings Quick start guide
28
` Selecting character density
and font
You can use the CPI (Character Per Inch) key in setup mode to select the number
of characters per inch to be printed. You can use the Font key to select fonts.
Press the Setup key. The printer changes to setup mode.
Press the Char (4) key.
Press the CPI (4) or Font (1) key (in our example, press CPI).
Use the < (2) or > (3) key to set the desired character density. Confirm the selec-
tion by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the Exit
(4) key.
If you pressed the Font (2) key, use the < (2) or > (3) key to select the desired font.
Confirm the selection by pressing the Set key.
You can cancel the selection and leave the setting unchanged by pressing the Exit
(4) key.
Press the Setup key. The printer returns to the initial status. It is also possible to
press the Online key. The printer then changes directly to online mode.
The selection made will not be retained after switching off the printer. For more
details on how to set the character density permanently, please refer to the User
guide on the Online CD-ROM.
Adjust Paprpath
Menu Char
Online
Setup
21
3
4
Font CPI
Online
Setup
21
3
4
Adjust Paprpath
Menu Char
Online
Setup
21
3
4
Quick
Start
-
en
.
book
Seite
28
Dienstag
,
15
.
September
2009
3:50
15