User Guide User Manual

2T model User guide
54
Paper guiding
bracket
Important: It is absolutely necessary to mount the paper gui-
ding bracket when using the rear tractor. It serves to protect
the mains and interface cables from being damaged by the
paper in the rear tractor.
Hook the paper guiding bracket at the bottom of
the printer as shown in the figure and then raise
it until it clicks into place by exerting gentle
pressure.
Selecting the rear
tractor
The rear tractor can be selected either from an application program,
the paper path quick selection or via the setup menu. This chapter
describes the paper path quick selection; for information on how to
make the setting in the Setup menu, refer to Setup mode.
Make sure that the printer is in offline mode; press the Online key,
if necessary.
Press the Park key (1). If fanfold paper is loaded in the printer, it is
transported to the tear position. Tear paper will be displayed. Then
press any key. If a single sheet is loaded in the printer, it will be ejec-
ted.
Press the Trac3 (4) key to select the rear tractor.
If you do not make a selection within 5 seconds, the
menu is closed.
The printer returns to offline mode.
The display alternates between the basic menu and:
STOP
Offline Trac1
Park Load
Online
Setup
21
3
4
Single Trac1
Trac2 Trac3
Online
Setup
21
3
4
Load paper from
Trac3
Online
Setup
21
3
4