User Guide User Manual

User guide Options and accessories

175

Options and accessories

Options The following options can be ordered for your printer.

Automatic cut sheet feeder,

front (ASF-F)

The automatic sheet feeder is suitable for single sheets. Paper for-

mats with a width of 150 to 365 mm may be used. Each format in

between can be set. The cut sheet feeder cannot be used in con-

junction with the optional tractor front.

Part no.: 061 906

Automatic cut sheet feeder,

rear (ASF-R)

The automatic sheet feeder with two bins is suitable for single

sheets. Paper formats with a width of 100 to 368 mm may be used.

Each format in between can be set. The single sheet feeder can only

be installed on the standard printer. It cannot be used in conjunction

with the autocut facility.

Part no.: 061 905

Autocut facility An additional module for automatic cutting (cannot be used in con-

junction with the automatic cut sheet feeder [ASF-R]).

Part no.: 061 907

Tractor 2, front The push tractor is suitable for fanfold paper. You can use paper for-

mats with a width in the range from 76 to 406 mm; you can set any

intermediate format.

Part no.: 061 052

Face down insertion An additional module for the automatic single sheet feeder. The sin-

gle sheets are output with the face down.

Part no.: 061 908

Printer pedestal A cabinet to be used as a printer stand and for storing fanfold paper

stacks.

Part no.: 061 910