Installation Guide Cutting Device User guide

Quick start guide Additional programming sequence

ENGLISH

Additional programming sequence

In addition to the MTPL programming sequences described in the optional Pro-

gramming Manual (ID: 379 298), the sequence for cutting at the current line is

available.

Data structure

ASCII ESC ,,[“ < n > ,,{“

hex. 1B 5B n 7B

dec. 27 91 n 123

Parameters

For the ESC [ n { sequence the following parameters are available for n:

1) above the line, the text to be printed was ended with a CR (hex.0D, dec. 13)

below the line, if the text to be printed was ended with a LF (hex.0A, dec.10)

Sequences for selecting the automatic single sheet feeder (ASF) are ignored. The

cutting of single sheets is not possible.

For further explanations regarding the available programming sequences please

refer to the Programming Manual, available at your dealer and on our internet site.

n hex. dec. paper feed and cutting

0 30 48 single sheet (manual)

5 35 53 fanfold paper tractor 1 (front, standard)

6 36 54 fanfold paper tractor 2 (front, option)

7 37 55 fanfold paper rear tractor

50 35 30 53 48 reposition at print position

51 35 31 53 49 cut fanfold paper at the next perforation

54 35 34 53 52 cut is made above/below the current line

QSG2280+2380

Cutdevice

Seite

Donnerstag

März

2008

3:22