Installation Guide Cutting Device User guide

Additional menu parameters Quick start guide
22
Additional menu parameters
` Setup menu After installation the cut device will be recognized automatically. Now an addi-
tional parameter is available within parameter group AutoCut (see also the corre-
sponding chapter Menu Description Table in the User Guide).
` Advanced menu After installation the cut device will be recognized automatically. Now additional
parameters are available, dependent on printer model (see section “Sync.Label pa-
rameter” on page 17 and “AED parameter” on page 19).
Which parameter is available depends on the printer model.
Parameter group Parameter Description
Auto Cut
( Auto Tear)
Cut on Formfeed If this parameter is set the paper will be
cut automatically at next perforation after
receiving a form feed (hex. 0C, dec. 12).
=
^
Parameter group Parameter Description
Paphand Sync.Label=On/Off Allows to synchronize the cut position
when using different paper ways.
or
AED=On/Off Corrects possible inaccuracies of the
paper positioning at the cut edge if the
paper path is changed after a cutting
action
QSG2280+2380
_
Cutdevice
_
en
.
fm
Seite
22
Donnerstag
,
20
.
März
2008
3:22
15