Quick Start Guide Manual

Settings Quick start guide
28
` Setting the first printing line
(TOF)
You can use the TOF function for setting the position of the first printing line for
each paper source and each menu individually.
Before using the TOF function (if fanfold paper is used), you first have to set the
tear position (see above).
Swing the soundproofing cover towards the front (see “Printer at a glance”,
page 5).
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bottom edge of the
first printing line
A is aligned with the tear edge B of the
printer. The factory setting for the first printing position
(TOF) is 12/72". This is equivalent to the second line from
the top.
Press the < (2) or > (3) key to move the first printing line to the desired position.
You can set values from 0 to 220/72" for fanfold paper or for single sheets.
12/72" corresponds to a printing line.
Adjust Paprpath
Menu Char
Online
Setup
21
3
4
TOF
Head Tear
Online
Setup
21
3
4
Com puterdrucker
Computerdrucker
A
B
FormAdj= 12/72"*
Set < > Exit
Online
Setup
21
3
4
Quick
Start
-
en
.
book
Seite
28
Freitag
,
16
.
Oktober
2009
1:20
13