Operator`s manual

WALL MOUNTING INSTRUCTIONS
A bracket suitable for attaching the printer to a wall is available
The bracket snaps into the bottom of the printer. Prior to use, two small 'break-outs' must be removed from the
battery cover of the printer as shown below:
Remove the two 'break-outs' using a
small screwdriver.
When attaching to a wall, the bracket must be located on the wall using screws and wall plugs as shown. The printer
may then be clipped into place and removed as required.
Use a finger or small screwdriver to
release the clip and then gently lift the
printer to remove from the wall bracket.
8