User guide

Special mode Set-Up mode
4-13
NETWORK menu
The following settings are valid for the optional internal Ethernet adapter only.
BUSY LINE DTR/RTS/SSD+/SSD- Selects the signal indicating that the
serial interface is in busy state (buffer is
full, printer is out of paper or an error is
detected). Valid only if the READY/
BUSY protocol has been selected.
DSR SIGNAL VALID/INVALID Sets the signal DSR (Data Set Ready)
valid or invalid.
DTR SIGNAL POWER UP/READY ON DTR is either set constantly to on
(power up) or is used for handshaking
(ready on).
BUSY TIME 200 ms/1 sec Selects the busy time of the serial inter-
face.
Parameter Value Description
IP ADDRESS 0,0,0,0 ... 255,255,255,255 Selects the IP address.
GATEWAY 0,0,0,0 ... 255,255,255,255 Selects the Gateway address.
NET MASK 0,0,0,0 ... 255,255,255,255 Selects the address of the Subnet mask.
Parameter Value Description