User guide

Special mode Set-Up mode
4-7
Options with Undetermined Values
For top and bottom margin parameters, you can choose among a continuous range of
values.
Example: Changing the Top Margin of the Single Sheet Feeder
This example shows how to change the top margin of the single sheet feeder from 0/
72 inch to 3/72 inch.
Enter the Set-Up mode: Turn the printer off and back on while pressing the SEL/
MENU key.
Select the FRICTION function: Wait for the printer to stop printing and press the
PARK/PRINT/q key seven times to select the FRICTION function.
Press the FF/LOAD/Micro Feed Up/u key to print the LPI parameter.
Press the PARK/PRINT/q key to print the TOP MARGIN parameter.
Press the FF/LOAD/Micro Feed Up/u key to print the current top margin value.
Repeatedley press the PARK/PRINT/q or the TEAR/p key until the desired
value is printed.
Press the SEL/MENU key to select the desired value and to activate the
SAVE&EXIT position.
Press the SEL/MENU key again to save the new value and exit the Set-Up mode
and return to the Ready state. These setting remain in effect until the next time they
are changed.
Points to Remember
} We recommend that you use continuous forms paper for printing in the Set-Up mode
because the output will exceed a single page.
} Whenever you enter the Set-Up mode, short help menus are printed at the top of the
page. Use the help menus for quick reference while in the Set-Up mode.
} When printing the option for each function, you can move either forward or backward
in the option list. To move forward (print the next option), press the PARK/PRINT/
q key. To move backward (print the previous option), press the TEAR/p key.
} While in the <FUNCTIONS> menu or when selecting a function that contains op-
tions and selectable values, press the SEL/MENU key to reprint the
<FUNCTIONS> menu SAVE&EXIT.