User's Manual

Installation
26 SkyZhone 45 Installation Guide
DR
A
FT
2 Every SkyZhone 45 component must be grounded through the terminal
marked with the international ground symbol. ( )
3 Slots and openings in the equipment are for ventilation. For reliable
operation and to avoid overheating, do not or block cover any slots or
openings in the system chassis.
4 DO NOT attempt to service this product yourself, or your warranty will
be void. Refer all servicing to Zhone Global Service and Support.
5 Special cables, which may be required by the regulatory inspection
authority for the installation site, are the responsibility of the customer.
6 When installed in the final configuration, the product must comply with
the applicable safety standards and regulatory requirements of the
geographic location in which it is installed. If necessary, consult with the
appropriate regulatory agencies and inspection authorities to ensure
compliance.
7 A rare phenomenon can create a voltage potential difference between the
earth grounds of two or more buildings that are interconnected through
installed communication links such as coaxial cables. Consult a qualified
electrical consultant to determine whether this phenomenon exists and, if
necessary, implement corrective action before installing the products.
8 Always use adequate Electrostatic Discharge (ESD) protection when
handling circuit card assemblies and other electronic parts.
9 DO NOT allow anything to rest on the power cord. Do not place the
product where the power cord could be walked on or damaged.