MESH-1200 Quick Installation Guide Document number: 830-04378-01 Inside the Box 1 x MESH-1200 Controller 1 x MESH-1200 Agent 2 x Power supplies 1 x CAT 5E cable System Description The MESH-1200 is a dual-band Wi-Fi router that can operate either as a single device, or as part of an EasyMesh ecosystem. The unit supports both layer two and three operation when in controller mode. In addition, the unit can also operate as a standard Wi-Fi repeater using the 5GHz radio.
/7 System LED description Indicator Color Behavior Power Blue Solid on Power on Off Power off WPS 2.
/7 Ports/Button WAN LAN1 LAN2 DC-IN WPS/Reset Description Color For a Controller unit: used to connect to the Internet (connection to the main Gateway) For an Agent unit: port may be used for: a) Wired connection to the LAN and the Controller b) Wired connection for user devices for internet access (e.g. Set Top Boxes, Smart TVs, Google Chromecast, etc.
/7 j) in between) Connect your device (phone, tablet or PC) to the EasyMesh network using the provided credentials on the Controller unit label: k) Process completed Continue only if you require to change the default credentials. 2) Setting router password and Wi-Fi credentials This process assumes you have already completed section 1. Using your PC, smartphone or tablet, open a browser and type http://192.168.10.1 in the search bar.
/7 The recommended configuration is to leave EasyMesh enabled. It is also recommended, but not mandatory, to configure the same SSID for both 2.4GHz and 5GHz radio. Once the desired names and passphrases have been defined, click “Compete” to save the configuration, or “Skip wizard” if you decide to keep the default credentials. After saving the configuration the Wi-Fi interface will reinitialize.
/7 Other settings (optional) Role setting The EasyMesh role function may be manually changed if necessary. To set up the EasyMesh ecosystem two units are required, one has to be set as “Controller” and one as “Agent”. Set router as Controller Navigate to "EasyMesh" > "EasyMesh settings" and click "EasyMesh enable" if not enabled by default; select the "Controller" role and click “Save”.
/7 Compliance Statement This document contains domestic and international regulatory FCC Part 15 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Introduction This document contains domestic and international regulatory FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
