User's Manual

66xx/67xx Router Users Guide 56
Add a PPPoE WAN Service
1. Add an EoA Layer 2 interface or an Ethernet WAN interface as described above (see Add an
ATM Layer 2 Interface on page 52).
2. Under Advanced Setup click WAN Service then click Add.
3. On the WAN Service Interface Configuration page, select the interface associated with the
PPPOE interface from the drop down, then click Next.
4. On the WAN Service Configuration page, select PPP over Ethernet (PPPoE).
5. Optionally enter a name if you wish to customize the description shown for the service.
6. Optionally specify the 801.1P priority and 802.1Q VLAN tagging parameters, and then click
Next. For untagged service, set the parameter to -1 to both 802.1P and 802.1Q VLAN ID.
By default the 802.1P and 802.1Q values are set to -1, which means that the parameters
are ignored.
7. Specify the address type, IPv4 only or dual stack (IPv4 and IPv6).
The IPv6 option enables IPv6 on the WAN interface. Use only when IPv6 is required.