User Manual

ZHONG 6738 User Manual
7
Figure 2 Rear panel
Figure 3 Side
panel
The following table describes the interfaces and the buttons.
Interface Description
DSL
RJ-11 port. Connect the router to DSL connector or splitter through
telephone cable.
LAN 4~1
RJ-45 port, for connecting the router to a PC or another network
device.
WAN For connecting Ethernet cable to provide Ethernet uplink.
Reset
Press the button for at least 2 second and then release it. System
restores the factory default settings.
USB1/2
USB port, for connecting the 3G network card or other USB storage
devices.
Power Power interface, for connecting the power adapter.
On/Off
Power switch.
WLAN WLAN switch, for enabling or disabling the WLAN function.
WPS
This button is used for enabling WPS PBC mode. If WPS is enabled,
press this button, and then the wireless router starts to accept the
negotiation of PBC mode.
Warning:
Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, please press the Reset button gently for 1 second with a fine needle
inserted into the hole and then release the button. The system reboots and returns to
the factory defaults.
3.2 Hardware Installation