User's Manual

Install the FiberJACK ONT
Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
43
Figure 16: 281x Models: Thread the fiber cable through the notch in the
circuit board.
Other than the connector type, fiber installation is the same for GPON
and GE models. See Manage the optical cable, page 54 and page 55
for more information.
h Remove the dust covers from the SC connector on the FiberJACK
ONT, and from the SC/APC or SC/UPC termination on the fiber
pigtail.
i Insert the fiber pigtail securely into the SC connector on the
FiberJACK ONT
j zNID 281x models: Replace fiber area cover.
Make sure the fiber does not get pinched when positioning the
FiberJACK ONT base assembly into the wallbox over the wallbox
mounting holes.
5 Secure the FiberJACK ONT to the wallbox
– For mounting into a plastic wallbox, the two self-tapping screws
(included) are used.
– For mounting into a metal wallbox, the two machine-thread screws
(included) are used.
a Insert one mounting screw into the upper mounting hole of the
FiberJACK ONT base assembly and turn it clockwise several
revolutions, but do not completely tighten it.
Leaving the screw loose will be sufficient to hold the ONT base
assembly in place while powering up the ONT and verifying that it
can range and connect to the OLT.
b Provide power to the circuit (via breaker or fuse)
c Turn on the Power Switch (lower left side of the FiberJACK ONT) by
sliding it to the ON (up) position.