User's Manual

Logging in to the 2800 Series ONT
Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
35
Logging in to the 2800 Series ONT
This section describes logging into the FiberJACK ONT locally with a
browser or CLI (telnet) using the subscriber facing LAN port, GE1. This
section assumes the ONT is in a default state with factory settings, including
the default factory IP address.
Figure 13: Log into GigE port to reach the Web UI or CLI on the zNID
Note: The 2800 Series ONT may be managed by other means,
however this guide only describes local management.
Note: If, after powering on, the FiberJACK ONT does not respond to
the browser, telnet or a ping test, reset the ONT to make sure the ONT
is in a known state. See Reset Button, page 31.
To login with a browser:
1 Connect an Ethernet cable from your computer to a GigE port on the
ONT.
2 Launch a browser and point it to 192.168.1.1.
3 Enter the username and password.
The default username/password is admin/zhone.
To login with a telnet session:
1 Connect an Ethernet cable from your computer to a GigE port on the
ONT.
2 Launch a telnet session and point it to 192.168.1.1.
3 Enter the username and password.
The default username/password is admin/zhone.