User's Manual

About This Guide
12 Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
• Prevent direct exposure to optical fiber ends or optical connector ends
where laser signals are directly accessed. Do not handle pieces of optical
fiber with fingers. Use tweezers or adhesive tape to lift and discard any
loose optical fiber ends.
• Wear rubber gloves to clean optical connectors. The gloves prevent direct
contact with the isopropyl alcohol and prevent contamination of the
ferrules with skin oils.
• Place all optical fiber clippings in a plastic container provided for that purpose.
• Handle optical fibers with caution. Place the optical fibers in a safe
location during installation.
• Follow the manufacturer instructions when using an optical test set. Incorrect
calibration or control settings can create hazardous levels of radiation.
Electrical Installation Instructions
WARNING! Installing electrical wires, especially for the AC
installations, may be hazardous and could lead to serious injury
or possibly death. Disconnect power before conducting the
installation. Take all proper precautions or have a qualified
electrician perform the tasks for installing electrical wiring.
• Installing electrical equipment may be hazardous. If you do not have the
skills necessary to properly install electrical wiring, do not proceed with
the installation, but have a qualified electrician perform the electrical
wiring part of the installation.
• Comply with all local building and electrical codes, including the wiring
gauge.
General Instructions
Other precautions to take before installing or servicing the product are as follows:
• Never install telephone wiring during a lightning storm.
• Never touch uninsulated telephone wires or terminals unless the
telephone line has first been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Only authorized service technicians can service this product.
Unauthorized service to this product can cause exposure to dangerous
high-voltage points or other risks and may result in injury or damage to
the unit and void all warranties.
• Special cables, which may be required by the regulatory inspection
authority for the installation site, are the responsibility of the buyer.