User's Manual
Table Of Contents
- Zhone zNID 27xx Series Hardware Installation Guide
- Table of Contents
- About This Guide
- zNID 27xx series
- zNID 27xx Installation
- Appendix: Pinouts
- Index
Connect to network
zNID 27xx Series Hardware Installation Guide
45
Figure 16: zNID-GPON-27xx models use SC/APC connector (green)
Figure 17: zNID-GE-27xx models use SC/UPC connector (blue)
2 Remove the dust covers from the SC optical connectors.
Clean the connector if necessary.
3 Plug in the fiber connector to connect the zNID to the network.
Note: To function properly the optical strength to the zNID
should be with the limits shown in Optical values for
zNID-GPON-27xx or Optical values for zNID-GE-27xx on
page 42.
4 Reattach the fiber service cover onto the zNID including the fiber service screw.