User's Manual

zNID 27xx Installation
40 zNID 27xx Series Hardware Installation Guide
2 Mark the hole positions.
The holes for the fiber tray are 17.4 cm apart (about 6 7/8 inches) on the
horizontal axis.
Figure 11: Mark on a level line
3 Drill the holes.
4 Attach the screws, leaving enough of the screw to slide on the mounting
bracket.
Use screws appropriate for the type of surface to which the unit is
mounted (i.e. wood, brick, CB, etc.).
5 Put the mount on the screws, then tighten the screws.
Figure 12: Attach the mount to the screws, then lightly tighten the screws.
The screws should leave enough space from being flush with the wall for
the zNID legs to hold the unit firmly against the wall.